Table - Coffee Table 1, Woodworking Plans
[ Pobierz całość w formacie PDF ]Free Project Plan - Coffee Table
PROJECT PLAN - COFFEE TABLE
This coffee table only needs two slots (rebates) cut in
the end frames to house the stretcher rail, there are
no other joints. An extra layer of ply wood is glued at
the top and either side of the leg sets and also at the
middle on each side of the stretcher rail. This allows
more scope when shaping. The stretcher rail is glued
in place and the glass top is firmly held with suction
mirror pads.
REQUIREMENTS
1.
Arbortech Rotary Shaping Tool (Woodcarver Kit, Industrial Kit, Mini Grinder, and/or Power
Chisel)
2.
Fitted to suitable 4 inch (100mm) or 4-1/2 inch (115mm) angle grinder.
3.
WOOD - 1 piece of plywood 1220 x 1350 x 19mm
4.
GLUE - White P.V.A. is adequate.
5.
PORTABLE JIG SAW
6.
3-6 F CLAMPS
7.
SAND PAPER - Sand with Arbortech Grinder Sanding Kit first use 40 grit then 80 grit. Finish
by hand with 120 grit.
8.
FINISH - Use a wax polish or brush applied varnish by choice.
9.
GLASS TOP - 1000 x 700 x 10mm with 50mm radius corners
4 x suction glass table pads. (to support glass). NB Any sturdy alternative to glass can be used
10.
SAFETY
- Safety glasses, ear plugs, dust mask & close fitting clothes.
METHOD
1.
to view and print scaled instructions to create a card template of the coffee table,
which can be made as described below.
1.
FIG 1 The lay up plan of how to trace your templates
on to the wood and the numbers of each shape you
need to cut out. with a jig saw.
FIG 1
- 1350 x 1220mm
Free Project Plan - Coffee Table
2.
FIG 2a&b. Glue the eight pieces of wood together in
each leg set, and the four pieces for the stretcher rail.
3.
Mark and cut out the 38mm wide rebates that houses
the stretcher rail as shown in FIG 3a. A full 'haunch joint'
may be used by cutting a
matching rebate in the
underside of the stretcher
rail as shown in FIG 3b.
Fig 3a
4.
FIG 4 Grip the work piece firmly and start by shaping
away the steps in the plywood.
Fig 4
5.
Now gradually shape the surface all over by rounding
edges and shaping as shown in FIG 5 a&b and seen in
the finished coffee table. There is scope to shape and
form the wood in alternative ways if you prefer.
Free Project Plan - Coffee Table
6.
The Arbortech Flexible Grinder Sanding Kit is used towards the end of shaping and is used to
cut away all the tool marks and allow you to fine shape and adjust the final profiles. After 40 grit,
use 80 grit and then hand sand.
7.
To obtain a good finish, first seal the pores of the wood with either a cellulose or oil sealing
compound. They are called grain sealers and obtainable from woodworking suppliers. Apply a
generous coat with a rag rubbing into the wood grain. Allow this to dry and sand lightly with a
fine sand paper. Apply another sparing coat of sealer with a rag, allow to dry. Apply polish or
varnish finish.
Back to Top
[ Pobierz całość w formacie PDF ]